Cleaning & Priming – adhesives - Innova Solutions
01282 867390 Technical Support FAQs

Menu
Generic selectors
Exact matches only
Search in title
Search in content
Search in posts
Search in pages
Filter by Categories
Video Demos
Growth Accelerator
News
Awards
Products
Technical Support
Uncategorized
Downloads
Development
Events
Launch
Announcements

Cleaning & Priming – adhesives

Cleaning & Priming – adhesives

Bonding surfaces are often covered with dust, dirt, grease, oxide films, rust inhibitors, or in the case of plastics, migrated plasticiser – these contaminants at a microscopic level can interfere with the adhesives ability to cement the surfaces together. Cleaning & Priming effectively reduces the likelihood of a bond failure.

Poor surface preparation is the primary cause of bond failure, and whilst demonstrating the requirements for our tape products, our Cleaning and Priming Instructions is equally applicable to liquid adhesive films.

For best results always ensure your surface is clean, dry and free from oil, grease and any other contaminants.

  1. If the surface is dirty, wash it with a detergent solution and dry thoroughly before proceeding.

  2. Abrade the surface (see What is abrading and why do I need to do it? below) then clean with a non-residual cleaning solvent such as NovaBond Surface Cleaner to remove any dust and create an ideal bonding surface.

 

IMPORTANT: Ensure you use the solvent in accordance with the manufacturer’s recommended guidelines.

Should you require any further information regarding NovaBond Surface Cleaner instructions please contact us at enquiries@innovasolutions.co.uk

Click HERE to link through to our full product range.

Innova Solutions: bonding people, fixing problems: +44 (0)1282 867 390

Connect with us

bonding people, fixing problems