01282 867390 Technical Support FAQs


Bonding to Powder Coat Overspray

Bonding To Powder Coat Overspray with NovaBond LSE80

  1. Whilst we always recommend abrading where possible, there may be some instances where aesthetics or production parameters do not allow for this secondary operation after the powder coat paint process
  1. When bonding to powder coat overspray there are 2 main considerations regarding the surface
  • Low surface energy to adhere to
  • Rough, uneven surface for the adhesive to wet out
  1. NovaBond LSE80 has been used by signmakers due to its high initial and ultimate adhesion to low surface energy substrates and specially formulated adhesive system that wets out and provides superior adhesion to irregular substrates
  1. Clean with a non residual solvent such as NovaBond Surface Cleaner
  1. Apply the NovaBond LSE80 tape to the acrylic panel
  1. Peel back the filmic liner and position the acrylic panel
  1. Remove fully the liner and apply firm pressure by means of a NovaBond Roller
  1. After application bond strength will increase as the adhesive flows into and wets out the surface. 60% strength will be achieved in 20 mins, 90 % after 24 hours and 100% after 72 hours.


Check out our other Best Practice Videos on our dedicated  YouTube Channnel


If you have any questions, please contact us at enquiries@innovasolutions.co.uk for further information.


Innova Solutions: bonding people, fixing problems: +44 (0)1282 867 390



Connect with us

Request a visit Request a call back for further information Call us today bonding people, fixing problems